10C
4-4.6 Display DMX channel
1. Press the Fine and Mode buttons at a time,the Assign LED
lights.
2. Press the Fine and Mode buttons the second time,the Assign
LED goes out and the Reverse LED lights.
3. Tap the Scanner button that holds the Pan and Tilt channel,
the LCD shows the Pan and Tilt.
4-5 Running Scenes
4-5.1 Manual Mode
1. When the power is turned on, this unit enters Manual mode automatically.This function
allows you to run a bank of programmed scenes in a sequential loop.
2. Make sure Auto and Music LEDs are both off.
3. Use the Bank Up/Down button to select the bank that contains the scenes you wish to run.
Page 23
4-2 Programming Scenes
1. Enter Program mode.
2. Press the Scanner button to turn on its fader control, which is
indicated by the lit LED.
You may select several scanners at a time by tapping of these
Scanner buttons, so you can set several scanners at a time.
3. Move the faders to select your desired dimmer intensity if you are using a dimmer.
You can also use the two jog wheels to control the Pan or Tilt movement of the scanner.
4. If necessary , you may tap the Page Select button to control
the second set of 8 DMX channels.
5. Once the scene is satisfactory, tap the MIDI/Rec button to
program this scene into memory.
6. Tap the Bank Up/Down button to select the bank you want to
store your scene into. There are total 30 banks you can select,
you may store up to 8 scenes into each bank.
7. Tap the Scene button to store your scene, all LEDs and the
Segment Display will flash three times briefly indicating this
operation, then the LCD will show the bank and the scene
Page 8