6A
6. How To Control the Unit
You can operate the unit in three ways:
A. By Master/slave Built-in Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other
units to give an automatic light show. You will know which unit is the master
because its DMX input jack will have nothing plugged into it. The other units
(slaves) will have DMX cables plugged into the DMX input jacks (daisy chain).
You can set the units in below two ways:
1.
Synchronized show:
set the first unit
（
master
）
dipswitch 1 and 10 to be ON at
the same time, so you can adjust the dimmer and
strobe speed, and all the other (slave) units will
run as same as the first (master) unit.
2.
4-Light show:
set the dipswitch as the diagram,
the first (master) unit will run the built-in
programmer and control the other (slave) units for
4-light show.
Chase pattern in 4-light show mode:
Pattern 1
1234 Full on
Pattern 2
1-2-3-4
―
4-3-2-1
Pattern 3
1-2-3-4-4-3-2-1
Pattern 4
12-34
―
23-14
Pattern 5
1-12-123-1234-123-12-1-stop
―
4-43-432-4321-432-43-4-stop
Pattern 6
1-2-1-2-3-4-3-4
―4
-1-4-1-3-2-3-2
B. By Easy Controller
The easy remote control is used only in master/slave mode. By
connecting to the 1/4” microphone jack of the first unit, you will find that
the remote control on the first unit will control all the other units for Stand
by, Function and Mode.
-- STAND BY
: stand by and blackout all the unit.
-- FUNCTION
:
• Under Audio status ( LED light off ), hold on the button,
all the units
will strobe quickly.
