ACKERMANN 16-2000-700, Инструкция по эксплуатации

Страница: 53 / 134

USER MANUAL 16-2000-700/701/702/703 Rev. 05/2018
HYSTERO CUT Monopolar cutting for gynaecological procedures
(hysteroscopy) in non-conductive liquids, e.g. purisol or glucose.
Instrument: loop electrode.
URO CUT Monopolar cutting for urological procedures.
This mode is used in difficult (wet) environment. It is necessary
for TURP and TURB procedures.
Instrument: monopolar urological resectoscope.
ARGON CUT Argon-enhanced monopolar cutting.
The argon cover reduces the amount of formed smoke and smell.
The thermal damage of tissues is reduced, and bleeding control
is improved. This function is particularly desirable during
procedures that require intensive use of device.
Instrument: needle- or lancet-type argon electrodes.
For additional information, see section 7.6.3
Argon modes are available only from output I and output II.
DUAL CUT Monopolar cut in simultaneous mode.
Cutting with 9 different effects of haemostasis. Enables the
activation of two monopolar handles simultaneously, therefore
two operators can perform action at the same time.
Specialistic mode, applied i.e. in cardiac surgery.
Instrument: monopolar electrodes, e.g. knife, loop, needle.
Cutting is usual performed using a knife or loop electrode, which is connected to a
monopolar handle, then to the monopolar or universal sockets
(Fig. 1 items 1, 2, 3,
4 – for HF 16-2000-700 system Version I), with the corresponding panels controlling
the respective outputs.
Before starting cutting, select the power or level, and the type of the desired effect
(see section 7.6).
In the case of polypectomy and papillotomy, select Cutting% and level (see section
8.5.2).
The type and parameters for monopolar cutting are set in the yellow part of the
panel, corresponding to the currently used output.
Page: 53 of 134