![background image](http://html1.mh-extra.com/html/acer/altos-t110-f4/altos-t110-f4_user-manual_3046316016.webp)
SuperWorkstation 5039D-I User's Manual
Chapter 3: Maintenance and Component Installation
28
29
Optional Drive Bays
The SC731i-300B chassis has two empty 5.25" drive bays that support optional devices such
as a DVD-ROM.
Installing an Optional Device
Begin by removing power from the system as described in section 3.1.
1. Remove the front bezel from the chassis by lifting it upwards from the bottom and
pulling off the front of the chassis.
2. Remove the cover plate from the optical device slot on the front of the chassis.
3. Install the bracket rail (A) onto one side of the device by inserting the pins of the
bracket into the mounting holes on the side of the device.
4. Slide the device into the chassis.
5. If desired, screws may be used to secure the device into chassis.
6. Attach the power and data cables to the drive.
7. Replace the chassis cover before restoring power to the system.
System Cooling
The SC731i-300B includes a super quiet rear system fan that provides cooling for the chassis.
No tools or screws are required to install the system fan.
Under normal operation, the chassis fan and the power supply fan both run continuously. If
the chassis fan fails, the system must be powered down before replacing it. If the power
supply fan fails, the power supply itself must be replaced.
Replacing the System Fan
Begin by removing power from the system as described in section 3.1.
1. Remove the left chassis cover as described in section 3-2.
2. Insert the four rubber pins into the four mounting holes surrounding the fan grill on the
rear of the chassis.
3. Place the system fan on top of the fan grill, aligning the mounting holes of the fan grill
with the mounting holes of the system fan.
4. Pull the rubber pins through the mounting holes of the system fan to secure the fan to
the chassis.
Figure 3-13. Installing an Optional Device
Figure 3-14. Replacing the System Fan
4
4
Bracket
Rail (A)
5