__________________________________________________________________________________
Superdryer 62 Owner’s Manual
4
Unit Set-Up
The unit will only function properly in a closed area. All windows and doors must be closed
to allow “drying” to occur.
WARNING
: It is recommended to remove dehumidifier from area if applying a liquid
vapor barrier. Some coatings dry via “solvent evaporation,” which can be harmful to certain
components in your dehumidifier. Allow coating to completely dry and exhaust vapors prior
to positioning dehumidifier. Read and follow coating manufacturer’s instructions completely.
Place dehumidifier on level surface
WARNING
– If during handling, the dehumidifier is moved in such a manner that the
compressor didn’t remain in a vertical orientation, wait a minimum of 2 hours before turning
the unit “on.”
Route drain line (3/4”
ID tubing on gravity drain, 3/8” ID tubing on units with
condensate pump) to drain or outside of the area. Note: On units with gravity drain,
Drain line must have a downward slope to drain. (Not applicable to units with
reservoirs)
Reference:
(Fig. 1/2),
De-
humidistat (7)
starts the functioning
of the dehumidifier when the humidity
is higher than the preset level. Air is
drawn in through the
filter (1)
flows
through the aluminium refrigerated
coil/
evaporator (2)
, through the
heat exchanger/
condenser (3).
Finally
, the motor fan (4)
expels the
air back into the room through the
front grilled panel. The condensed
water is collected in the
tank (5)
. A
micro-switch
(6)
stops the machine
when the water in the tank reaches
the correct level activating the full
circuit. An
electronic circuit
(8)
controls the defrosting
and
prevents
the
compressor
(
9
) from short
cycling.
Fig. 1
Machines with water
reservoir
Fig. 2
Machines with condensate pump
