30
User's manual | Vision™ Combi Steamers I
09 ERROR MESSAGE TABLE
09 I ERROR MESSAGE
TABLE
There could apear error messages on the display during the cooking process.
Their meaning is as follows:
Err 11
Chamber heating element
error.
The combi oven cannot
continue operating.
Contact an authorized
service company.
Err 15
Failure of motor heat
protection. Signals motor
overheating above the set
limit.
Contact your authorized
service comany.
Err 26
Exhaust valve error. The
automatic flap valve is not
working correctly.
Incorrect function of
the flap valve may affect
cooking results, however,
it is possible to continue
using the combi oven
temporarily. Contact
an authorized service
company.
Err 31
Drain heat sensor error.
The combi oven can
temporarily be used
in all modes. Contact
an authorized service
company.
Err 35
Chamber heat sensor error.
Error blocks work in
all modes. Contact
an authorized service
company.
Err 36
Error of the 6-point
temperature probe.
The combi oven can
temporarily be used in all
modes with the exception
of the modes with a
temperature probe. Contact
an authorized service
company.
Err 37
Thermistor disconnected.
Contact an authorized
service company.
Err 38
Thermistor short-circuited.
Contact an authorized
service company.
Err 41
Cooling error - overheating
of electronics.
Clean the dust filter.
If the error occurs
repeatedly, please contact
an authorized service
company.
Err 60-
79
Modbus communications
error.
Disconnect the power
supply to the combi oven
(not “Standby” mode), wait
30 seconds and then turn
on the combi oven again
(reconnect the power
supply). If the problem
reoccurs, please contact
an authorized service
company.
Err 80-
91
Frequency converter error.
If the problem reoccurs,
please contact an
authorized service
company.
Err 95
Incorrect blower speed.
If the problem reoccurs,
please contact an
authorized service
company.
Err 96
Lighting up error.
Check that the gas supply is
open and reattempt to start
cooking. If the problem
reoccurs, please contact
an authorized service
company.
Err 100
System error.
Contact an authorized
service company.
•
Equipment failures can be repaired by authorized service only, which
is trained and certified by the manufacturer. Warranty does not apply
in the case of improper or unauthorized service!
