
24
25
STEP 7 – Following completion of session
n
To turn off the device, press the “On/Off”
button.
n
Remove the electrode pad and device from the
skin. Detach from the edges.
n
Remove the device from the electrode pads. If
the device is inactive for more than 5 minutes, it
enters sleep mode.
NOTES
n
Remove the batteries if the device is not in use
for long periods of time.
DO NOT
mix old and new batteries or
different types of batteries.
n
Remove exhausted batteries from the remote
control.
CAUTION:
Batteries
MUST
be handled
by an adult. Keep batteries out of the
reach of children.
n
To conserve battery life, after 5 minutes of use,
the display of the remote control will enter
sleep mode and the display will go dark. The
device will continue to run and administer
treatment. To reengage the remote control,
press the power button and the screen will
reactivate. To end treatment while the remote
is in sleep mode, reactivate the screen and hold
down the power button until the remote turns
off. Always make sure the remote is powered
off before removing the electrode pads from
your skin.
Cleaning the remote control
1)
Turn unit off.
2)
Clean the device after use with a soft,
slightly moistened cloth and wipe gently.
Use only water and a mild soap if needed.
n
DO NOT
use chemicals (like thinner,
benzene).
n
DO NOT
let water get into the internal area.
NOTE:
This device and accessories do not require
sterilization.
Cleaning the electrode pads
1)
Turn the power off.
2)
Remove pads from device.
3)
Wash the pads with water only when the
adhesive surface becomes dirty and/or the pads
are difficult to attach.
n
Wash the pad softly with your fingertips under
CLEANING AND STORAGE
slow running cold water for several seconds
(
DO NOT
use a sponge/cloth/sharp object
like a nail on the adhesive side.
DO NOT
use detergents, chemicals or soap).
4)
Dry the pads and let the adhesive surface
air-dry completely (
DO NOT
wipe with a tissue
paper or cloth).
CAUTION
n
The life of pads may vary by the frequency of
washing, skin condition, and storage state.
n
If the pad no longer sticks to your skin or the
pad is broken, immediately discontinue use and
obtain replacement pads as recommended by
the manufacturer.
n
Before applying the self-adhesive electrode
pads, it is recommended to wash and degrease
the skin, and then dry it.
n
DO NOT turn on the device when the
electrode pads are not positioned on the body.
ACRL3100_Manual_03.indd 24-25
10/31/18 4:41 PM