Accu-Sort
®
Systems, inc.
511 School House Road
Telford, PA 18969 U.S.A.
1-800-BAR-CODE
1-(215)-723-0981
This copy expires 7 days after: 8/25/06
unless stamped "CONTROLLED
COPY" in red
Issued: 07/06/05
Revised:
TP-ENM-704
Rev.
A
Page 2 of 22
Annotations to this document are acceptable only if done in RED pen and initialed by a
representative of the department responsible for the creation and maintenance of the document
RFR-02 READER TEST PROCEDURE
______________________________________________________________________________
THIS IS A CONTROLLED COPY ONLY IF STAMPED “CONTROLLED COPY” IN RED.
©
Accu-Sort Systems, inc.
BNC – BNC Test Cable
Test Laptop or PC (Win32)
Tools Required (cont.)
RFR-02 Power Supply w/AC Cord
ISO
15693
RFID
Tag
RFID Tag 7” Test Stand
Input
Test
Wiring
Harness
Output
Test
Wiring
Harness
Serial Cable (9pin Male – 9pin Female) w/Pins 2, 3, and 5 Straight
B&B
Electronics
Model
#485PTBR
RS232-RS422
Converter
7.0 PROCEDURE
7.1
Remove the lid from the RFR-02.
7.2
Check external and internal hardware tightness and cable installation (make sure the wiring
harnesses are correctly aligned on their headers, off a pin, etc.).
7.3
Remove the metal cover from the RF section of the board with a flat screw driver.
7.4
Inspect
. Visually inspect component soldering quality, particularly the inductor area.
7.5
Install shield over RF section, ensure that all fingers alternate around cover and are gripping
tight.
7.6
Plug in serial cable (RS232) from COM1 of Test PC to the “SETUP” port on the RFR-02.
7.7
On the Test PC, run the program “rfr02setup.exe”.
7.8
Plug in AC power to the RFR-02 reader.
7.9
In the rfr02setup program, go to “Update Firmware”.
