Accu-Sort 10, Руководство по эксплуатации и обслуживанию

Страница: 6 / 102

IV
S
AFETY
R
ECOMMENDATIONS AND
P
RECAUTIONS
The Model 10 is an electronic microprocessor-based bar code scanner. Please
follow the safety precautions and warnings found throughout this manual in order
to prevent personal injury or damage to the unit. Failure to follow these
precautions may void your warranty.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
The following note boxes are displayed throughout this manual to indicate safety
concerns and/or warnings.
This note box is used to alert the user they are about to perform an action
involving a dangerous level of voltage, or to warn against an action that could
cause electrical shock.
This note box is used to provide precautions and/or guidelines, warning the user
that personal injury or damage to the unit may occur during the task they are
performing.
W
HEN
U
NPACKING AND
M
OUNTING
•
Do not drop the unit, internal damage may result
•
Do not touch the exit window glass. Fingerprints on the glass may diminish
scanner performance. If the window becomes dirty, refer to Exit Window
Cleaning in Chapter 6.
WARNING
This is a Class A product. In a domestic environment this product can cause radio
interference in which case the user may be required to take adequate measures.
(ref. CISPR 22 = EN 55 022:1995)
WARNING
In order to maintain Electromagnetic Compatibility (EMC) Compliance
interconnecting cables must be connected using a 360
°
shield connection of all
the interface cables with a conductive strain relief for RF shielding purposes
(i.e.:’metalized’ ’D’ sub-strain relief). This applies to all I/O cables connected
through ’D’ sub-connectors.
CAUTION – Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous laser light exposure.