Accu-Sort 10, Руководство по эксплуатации и обслуживанию

Страница: 30 / 102

2-4 M
ODEL
10 O
PERATIONS AND
M
AINTENANCE
M
ANUAL
Accu-Sort Systems
O
BJECT
-S
ENSING
S
IGNAL
D
EVICE
The Model 10 must be informed when an object on the conveyor is about to enter
its reading zone. An object-sensing signal device is typically used to do this. The
device is mounted on the conveyor upstream from the Model 10 in relation to
conveyor travel. It informs the Model 10 when the leading edge and trailing edge
of objects traveling on the conveyor have passed.
The typical object-sensing option for use with the Model 10 is:
•
Retroreflective Pair: An emitter bounces a light beam off a reflector, and
detects when the beam is broken.
The object sensing signal device will be connected to the 9-pin female connector
TRIGGER (J2) on the Small Scanner Interface, or the terminal block connector
on the EM-50.
You must use shielded interface cables with the Model 10. To maintain FCC
compliance, the cable shield must make a 360
°
connection to the shielded mating
connector.
For mounting instructions on your object-sensing signal device, refer to shipkit
1000020527. For setup instructions, refer to the Accu-Setup Suite: Small Scanner
Module Software Manual.