Gear rack installation
1) Fix the three nuts (on the same rack package) on the rack element.
2) Put the first piece of the rack on the gear and weld the first nut on the door.
3) Move the door manually, check if the rack is resting in the gear and weld the second and third nuts.
4) Attach the other element of the zipper followed by the previous zipper. Move the door manually and weld the three nuts
as in the first rack, proceed until the door is fully covered.
5) When the guide is properly installed, make sure the racks engage properly with the gear.
6) The space between the rack and the gear should be 0.5mm.
Figura 4
Spring switch limit
1) To ensure safety, it is recommended to install limit switches at both ends of the door to prevent the door from sliding off
the rails. The profiles are mounted horizontally.
2) Install the limit block, as shown in figure 5 and figure 6. The spring limit switch and blocks are used to control the position
of the door.
3) Release the gear with the key and push the sliding door manually to preset the position, fix the rack block and lock the
gear push up the release bar. When moving the door electrically, adjust the block in the correct position until the position of
the opening and closing meets the requirement.
Opening your life
Code:
PB400
www.accessmatic.com
Opening your life
1
