44
green when charging and light will turn off then
fully charged.
It is recommended to keep the tug and remote
controller charging
when not in use
.
Tug is overloaded
Reset the circuit
breaker(s). Turn off the
remote controller and tug.
Open the magnetic tug
cover and locate the
circuit breaker(s) on the
PC board. Press the
button(s) down to
deactivate the circuit
breaker (If it is active you
will feel some resistance
from the button). See the
critical note in the “Details”
section.
Steep inclines, towing above the tug’s capacity,
and sudden stops can cause the tug to activate
the circuit breaker.
CRITICAL NOTE: If the circuit breaker
continues to activate after being reset, the tug is
being overstressed and could cause damage to
the circuit board. Address any mechanical
issues, such as a seized sprocket or missing
track retainer clips or any driving conditions,
such as driving up a steep incline or towing
above the tugs capacity that could cause the
tug to overstress. If the issue persists, call or
email AC Air Technology tech support for
further assistance.
Remote controller and
receiver are not binding
Rebind remote controller
and receiver.
Call or email tech support for further assistance
One track
turns but the
other track
does not
Speed controls are not
plugged into radio receiver
correctly
Turn off the radio
controller and tug. Open
the magnetic tug cover.
Visually inspect the wire
from the speed control to
the receiver on the PC
board for any damage. If
there is damage, replace
the speed controls.
Verify that the wires from
the speed controls are
connected to slot numbers
1 and 2 on the receiver.
Ensure the connections
are fully engaged
If there is damage to the speed controls, the PC
board may need to be replaced. Call tech
support for further assistance.
Gearbox failure
Open the tug cover and
visually inspect the motors
for any obstruction. With
the radio off, carefully
clear any obstruction.
With the cover open, radio
on, visually check if the
motor(s) are turning. If the
motor(s) are turning but
the track is not, the
gearbox needs repair.
Call or email tech support for further assistance
Tug operating
sluggish/ low
power
Tug is being operated on
LOW or MEDIUM Speed.
Switch speed setting on
remote controller to HI
speed. (Rabbit Icon)
HI speed mode enables the tug’s full power. It is
recommended to use the tug in HI speed mode
when operating outside, in an open area. LOW
and MEDIUM speed modes are helpful when
operating in small quarters for precise
positioning.
