42
button. LED 2 lights up.
Confirm by pressing SET.
LED 7 lights up again. Set dip switch 3 of the accessory
module to ON.
Exit the programming mode by pressing ESC/DEL.
The LED for the power supply lights up/flashes and the fault
LED lights up. The accessory module beeps at short intervals.
Close both tamper contacts of the WAM and wait until it emits
a double tone.
2. On the wireless alarm system, select “Add Other
Devices/Wireless Accessory Module” and follow the installation
instructions for the alarm system. When prompted, trigger the
tamper contact of the accessory module and wait until the
wireless alarm system receives the signal from the accessory
module.
The accessory module is now trained as a wireless output
module. This step is not necessary for stand-alone operation.
Remove all jumpers for controlling the outputs. To program the
relay, follow the instructions in the wireless alarm system
manual (“Programming outputs”).
3. The relay outputs can be programmed individually to work as
NC instead of NO. Reprogramming relay outputs affects all
function modes. To reprogram the relay channels, proceed as
follows:
In the main programming menu, select item 5 (LED 5 lights
up).
Confirm by pressing SET.
LED 1 lights up or flashes to show output 1.
You are now in the submenu of item 5. Select the output where
the polarity is to be changed. To select the output, press
SELECT.
Confirm the selection of the output by pressing SET.
The LED of the selected output flashes or lights up.
To change the polarity of the output, press SELECT.
A constantly lit LED means that this output is programmed as
NO.
A flashing LED means that this output is programmed as NC.
After setting the polarity of the output, confirm the selection by
pressing SET.
You now return to the output selection menu.
After setting the outputs, exit the programming mode by
pressing ESC/DEL.
The LED for the power supply lights up/flashes and the fault
LED lights up. The accessory module beeps at short intervals.
