![background image](http://html1.mh-extra.com/html/abs/comtrak-1700/comtrak-1700_installation-and-start-up-procedure_3496124006.webp)
Specification #8810502
Original 5/14/98
ABS<Comtrak
1700-1702
Installation & Start-up Procedure
6
Revision, 1/5/99
ALIGNMENT
PIN GROOVE
INDEX TAB
INDEX TAB
ALIGNMENT
PIN
TITLE
Figure 2 - Wireless cuff
1. Install O-Ring over battery hub.
2. Align the index tabs and press to mate the two sections. DO NOT TWIST to
align the index tabs. If the tabs are not aligned, pull the sections apart and re-
seat. Sections WILL NOT MATE if the alignment pin is not seated in the
alignment pin groove.
3. Using a #1 phillips screwdriver, install the four screws.
4. Install the cuff strap. Make sure the metal tab on the cuff strap will contact the
metal contact in the transmitter assembly and push the cuff tab into a recess of
the transmitter assembly. Loop the strap around the arm or leg, holding the
transmitter assembly with the screws (battery section) against the arm or leg, and
snap the other end of the cuff strap into place.
O-RING
SCREW 4 EA
STRAP ASSY
BATTERY
TRANSMITTER
BATTERY HUB