Specification #8810502
Original 5/14/98
ABS<Comtrak
1700-1702
Installation & Start-up Procedure
5
Revision, 1/5/99
•
Training the cuff.
This is done by first placing a magnet on the outside of the bag over the
wireless antenna and then placing a separate magnet over the body of the transmitter. As a
general rule, hold the magnet over the transmitter for a minimum of 5 seconds. If you are
using the Cuff Tester the red LED will blink while the receiver is properly being trained to the
cuff. Remove the magnet from the receiver and leave the magnet on the transmitter. The
buzzer on the Cuff Tester will beep repeatedly if the cuff is properly trained. If it doesn’t,
repeat the process over again this time training it longer than five seconds.
Note: Some magnets may not be strong enough to properly train the wireless receiver
through the black bag. In this case it is necessary to unzip the bag and slide the magnet
down the side of the unit placing it directly on the metal cover keeping in mind the
location of the receiver.
White GPS
antenna housing
Wireless
receiver location
Blank side with
identification tag
facing away
Blinking red
LED indicating
that cuff is
training
successfully
Magnet being
placed on body
of the
transmitter.
First magnet
being held over
the wireless
receiver.
