ABM International LA-763, Инструкция по эксплуатации

Страница: 7 / 71

LA-763: V1.1
5
SECTION 2.0 – Machine Setup
The LA-763 ships fully tested ready to operate. As a result, this manual provides a
section on machine setup so that you can install the machine. Please read this manual in
its’ entirety and follow all ABM instructions, especially the inspections. Total setup time,
less power and air hook-up, should take approximately 1 hour.
SETUP INSTRUCTIONS:
INSPECTION #1: Upon receipt of the machine, check to ensure that there is no visible
damage. Figure 0.1 and the front cover of this manual are enough for this inspection.
Note: that some components may be in different locations depending on the version
of the machine.
Determine the location in your facility for the sewing machine. Attach the eight (8)
machine legs supplied with the machine to the plates that were used to bolt the machine
to its skid. Level and position the machine in the desired location. Though not required,
ABM recommends that the machine be bolted to the floor. Place the foot pedal in front
of the machine on the floor and connect it.
Run a 220VAC line (15AMP) to the machine location. Though the machine does not
come equipped with a 220V plug, “ABM” does not recommend the use of any type of
extension cord to power the machine. As with any machine, power should be run
through approved conduit and ducting with proper termination. ABM does not supply a
main power disconnect with the machine and recommends that the customer install one.
You may connect the power to the machine at this time.
INSPECTION #2: Will confirm that the electronics of the LA-763 long arm sewing
machine are functioning properly.
WARNING
: ELECTRICAL SHOCK HAZARD. THIS INSPECTION WILL
REQUIRE POWER TO BE ON WHILE THE ELECTRONICS CABINET IS
OPEN. IF A PROBLEM IS FOUND, YOU SHOULD NOT ATTEMPT TO
REPAIR IT WITH THE POWER ON. DISCONNECT THE MACHINE PRIOR
TO ADJUSTING ANY COMPONENTS WITHIN THE ELECTRICAL CABINET.
Step one; open the electronics cabinet located on the right vertical end-stand of the steel
bridge of the machine. The internals of the cabinet will look like Figure 1.0. From top to
bottom the components are as follows: Lamp power supply, servo motor, servo motion
controller .
Upon power up, the sewhead needles up.