Abit VL6, Руководство пользователя

Страница: 10 / 112

2-2 Chapter2
VL6
motherboard with studs. If the holes line up and there are only slots, this means you can only
attach the motherboard with spacers. Take the tip of the spacers and insert them into the slots.
After doing this to all the slots, you can slide the motherboard into position aligned with the
slots. After the motherboard has been positioned, check to make sure everything is OK
before putting the casing back on.
Figure 2-2 shows you the way to affix the motherboard using studs or spacers:
Note
If the motherboard has mounting holes, but they don’t line up with the holes on the base
and there are no slots to attach the spacers, don’t worry, you can still attach the spacers to
the mounting holes. Just cut the bottom portion of spacers (the spacer they may be a little
hard to cut, so be careful with your hands). In this way you can still attach the
motherboard to the base without worrying about short circuits. Sometimes you may need
to use the plastic springs to isolate the screw from the motherboard PCB surface, because
the circuit wire may be near by the hole. Be careful, don’t let the screw contact any the
printed circuit wire or parts on the PCB that are near the fixing hole, otherwise it may
damage the board or cause board malfunctioning.
2-2. Installation of the Intel
®
Celeron
™
(PPGA & FC-
PGA) & Pentium
®
III (FC-PGA) processors
The Intel
®
Celeron
™
(PPGA & FC-PGA) & Pentium
®
III (FC-PGA) package processor
installation, is easy, like Socket 7 Pentium
®
processors before. Because it uses the “Socket
370” ZIF ( Z ero I nsertion F orce) socket, it lets you easily fix the processor on to its position
firmly. Figure 2-3 shows you what the 370 socket looks like, and how to open the lever. Its
pin count is more than socket 7. Therefore, a Pentium level processor cannot be inserted into
socket 370.
When you raise the lever, you have to loosen the socket lock. Please raise the lever to the end,
and prepare to insert the processor. Next, you need to align the processor pin 1 to the socket
pin 1. If you put it in the wrong direction, you will not be able to insert the processor easily,
and processor pins will not fully go into the socket. If that is the case, please change the
direction, until it easily and fully inserts into the 370 socket. See Figure 2-4.
When you finish the above, push the lever down to its original position, and you should feel
the lever lock up the 370 socket. You have then finished the processor installation.