EN
-
24
8 Putting out of operation
xFUME
®
POWER 250
7.2 Two-step manual mode
In manual mode, the wire feed speed and welding voltage can be set independently of each other.
7.3 Gas test
7.4 Wire feed
8 Putting out of operation
1
Turn the control dial to set the wire feed speed.
2
Turn the control dial to set the welding voltage.
1
Push the toggle switch to the left to activate the
gas valve.
The gas valve remains open for as long as the toggle
switch is actuated.
1
Push the toggle switch to the right to activate the
wire feed.
The welding wire is fed in for as long as the toggle
switch is actuated.
1
Switch off the welding power source by pressing
the OFF switch on the rear side.
2
Disconnect the device from the power supply.
3
Disconnect the device from the gas supply.
Содержание xFUME POWER 250
Страница 37: ...xFUME POWER 250 13 Gewährleistung DE 37 ...
