![background image](http://html1.mh-extra.com/html/abicor-binzel/en-60-974-7/en-60-974-7_operating-instructions-manual_451510039.webp)
EN - 19
MT/AUT/AUT RAB
10 Troubleshooting
Problem
Cause
Solution
Torch becomes too hot
• Contact tip / Tip adapter loose
• Check and tighten
Torch becomes too hot
• Power connections loose on the
torch side and toward the work-
piece
• Coolant flow too low
• Check and tighten
• Check cooling system, increase
coolant flow
Wire burned solid in the
contact tip
• Wrong parameters set
• Worn-out contact tip
• Adjust wire burn-back function
• Check or correct setting
• Replace
• Correct
Irregular wire feed
• Guide spiral liner/PA liner
clogged
• Contact tip and wire diameter not
tuned to one another
• Wrong contact pressure set on
the wire feed unit
• Clean both directions with
compressed or replace it, if
necessary
• Replace contact tip
• Correct as specified by
manufacturer
Arc between gas nozzle
and work-piece
• Spatter bridge between contact
tip and gas nozzle
• Clean and spray gas nozzle
interior
Unsettled arc
• Contact tip not matched to the
wire diameter or contact tip
diameter enlarged
• Wrong welding parameters set
• Wire guide unit worn-out
• Check the contact tip and
replace it if necessary.
• Correct welding parameters
• Replace wire guide unit
Pore formation
• Strong spattering in the gas
nozzle
• Insufficient or missing gas cover
• Air draughts blow shielding gas
away
• Clean gas nozzle
• Check gas cylinder contents and
pressure setting
• Shield welding area with
partitions
Tab. 11
Troubleshooting