DE - 14
6 Inbetriebnahme
MT/AUT/AUT RAB
Bei jeder Erstinbetriebnahme bzw. nach jedem Schlauchpaketwechsel müssen
Sie das Kühlsystem wie folgt entlüften. Führen Sie folgende Tätigkeiten durch:
1
Kühlmittelrücklauf-Schlauch
am Umlaufkühlgerät
lösen und über
einen Auffangbehälter halten.
2
Die Öffnung am Kühlmittelrücklauf-Schlauch
wiederholtes, abruptes Öffnen wieder frei geben, bis das Kühlmittel
kontinuierlich und blasenfrei in den Auffangbehälter fließt.
3
Das Umlaufkühlgerät
ausschalten und den Kühlmittelrücklauf-
wieder anschließen.
HINWEIS
• Verwenden Sie kein deionisiertes oder demineralisiertes Wasser als
Kühlmittel oder für Dichtheits- und Durchflussprüfungen.
Dies kann die Lebensdauer Ihres Schweißbrenners beeinträchtigen.
• Wir empfehlen für flüssiggekühlte Schweißbrenner die Verwendung von
ABICOR BINZEL
Kühlmittel BTC-15.
1
Kühlmittelrücklauf-Schlauch
2
Kühlmittelvorlauf-Schlauch
3
Umlaufkühlgerät
Abb. 6
Kühlmittel anschließen
1
2
3
HINWEIS
• Wiederholen Sie diesen Vorgang so lange, bis das Kühlmittel
kontinuierlich und blasenfrei abläuft.
• Kontrollieren Sie die Mindestfüllmenge am Kühlgerät.