Abicor Binzel DAV, Руководство по эксплуатации

Страница: 14 / 18

EN - 14
BAL.0789.0 • 2020-03-02
9 Maintenance and cleaning DAV
9.2 Replacing the cutter
The service life of the cutter depends on the filler wire to be cut.
1 Carefully unscrew the cover (1) with lubricating nipple.
2 Unscrew and replace the cutter (5) .
3 Screw the cover (1) back on again.
4 Check the fixed jaws (3) for wear; reverse or replace if necessary.
NOTICE
• Worn-out cutting edges may cause malfunctions. A cost- and time-saving remedy is correcting the start-up position by a
few millimeters. Only when the entire cutting width of the cutter has been worn out, will a replacement be required.
1 Cover
2 Counter support with pressure spring
3 Jaws
4 Housing
5 Cutter
6 Slide
Fig. 8 Replacing the cutter
CAUTION
Risk of injury due to spring tension of counter support or cutter
• Interrupt the device’s compressed air supply.
• Keep your hands out of the danger zone.
1
2
3
4
5
6