DE - 11
ABIPLAS
®
WELD CT Plasma Drive
6 Inbetriebnahme
6.1 Brennerkörper ABIPLAS
®
WELD
150 CT20 a
usrüsten
1
Zentrierkeramik über Wolframelektrode stecken.
2
Wolframelektrode mit stumpfen Ende ca. 5 mm tief in Brennerkappe
einstecken.
3
Alle Teile in den Brennerkörper stecken und mit Brennerkappe
festschrauben.
4
Eingeschraubte Brennerkappe um eine halbe Drehung gegen den
Uhrzeigersinn lösen.
5
Einstelllehre bis zum Anschlag von unten in Brennerkörper schrauben.
Dabei wird die Wolframelektrodenspitze auf das Einstellmaß zurück
geschoben.
6
Brennerkappe fest drehen. Wolframelektrode wird geklemmt.
7
Einstelllehre abschrauben und Isolierring aufstecken.
8
Gasdiffusor aufschrauben.
9
Plasmadüse mit der Einstelllehre fest in den Brennerkörper einschrauben.
HINWEIS
• Die Inbetriebnahme der
Plasma Drive
Schweißbrenner darf nur durch
geschultes Personal erfolgen.
VORSICHT
Verletzungsgefahr
Durchstich bzw. Einstich durch Wolframelektrodenspitze.
• Nicht in den Gefahrenbereich greifen.
• Schutzhandschuhe tragen.
Abb. 4
Handlungsschritte Brennerkörper
ABIPLAS
®
WELD
150 CT20 a
usrüsten
1-2
3-4
5-6
7-8
9
10
Содержание ABIPLAS WELD CT
Страница 30: ...DE 30 12 Entsorgung ABIPLAS WELD CT Plasma Drive ...
Страница 58: ...EN 29 ABIPLAS WELD CT Plasma drive 12 Disposal ...
Страница 59: ...EN 30 12 Disposal ABIPLAS WELD CT Plasma drive ...