R1
IP66
OUTDOOR
MODEL
P06005000
www.lanzini.it
EN
INSTRUCTIONS
INSTALLATION, USE AND MAINTENANCE
-
Warning!
Security of the fitting is guaranteed only with the appropriate use of the
following instructions: therefore it is necessary to preserve them.
-
Warning!
Before connecting to the main network, during assembly or
replacement of the product, make sure to disconnect the tension.
-
Warning!
The product has to be repaired only by professional technicians or by the
manufacturer.
- During product installation respect carefully the plant rules.
- The fitting should be used only if complete with its protection screen; This is a
polycarbonate lens(3mm thick tempered glass can be supplied on request).
- For any replacement contact the manufacturing company.
- The fitting must be installed by a professional electrician.
- The fitting cannot be modified or tampered with in any way, any modification may
compromise security by making it dangerous. The manufacturer declines any
responsibility for the modified products.
- Class I fitting must be connected to the ground circuit of the electrical plant.
- Keep at least 1 m between the fitting and the illuminated surface.
- Fitting suitable for outdoor applications. Protection degree IP66.
- Fitting suitable for direct mounting on normally inflammable surfaces.
- Remove the wall mounting flange by unscrewing the n° 2 side screws.
- Install the wall fixing flange using n°2/3 fischer, with a minimum diameter of 6
mm.
- Make sure that the fixing flange is securely connected to the wall (fig. A).
- Connect the power cables to a triple connector that can guarantee a minimum
protection degree IP67 (fig.B). Lanzini provides this connector (code L93062000) as
a separate mounting kit, on request; alternatively, you can use a similar connector.
- Position the fitting with the required inclination using the appropriate goniometer
placed on the bracket, and tighten the screws previously removed (fig. C).
- Make sure you have done everything correctly and reconnect the tension (fig. D).
- Do not stare at light source.
-
Warning!
Risk of electric shock
- For use in environments where an accumulation of non-conductive dust on the
luminaire
1 m
Power supply:
220-240 V AC - 50/60 HZ
Power
Weight
Dimensions
Surface exposed to the wind
80W
2,7 Kg
348×190×94 mm
0,051 m² 0,011 m²
100 W
2,7 Kg
348×190×94 mm
0,051 m² 0,011 m²
110 W
2,7 Kg
348×190×94 mm
0,051 m² 0,011 m²
Operating temperature:
-40° +45°C
Insulation class:
I
BLANK EXTERNAL DRIVE
EP s.p.a. Via del Commercio 1 - 25039 - Travagliato (BS) - ITALY
IT
-Questo prodotto contiene una sorgente luminosa di efficienza energetica classe
EN
-This product contains a light source of energy efficiency class
D
