Abicor Binzel ABIMIG SpinArc, Руководство по эксплуатации

Страница: 44 / 48

EN - 22
11 Disassembly ABIMIG
®
SpinArc
®
11 Disassembly
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (change body, bracket, CAT robot mount, torch neck).
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. To correctly dispose of the product, it must first be disassembled.

11 Disassembly on page EN-22
Deviating rotation
diameter
• Excessive wire feeding • Mount the wire straightener at
the wire feeder inlet
• Flexure damaged • Replace flexure

9.6 Flexure on page EN-17
• Tip adaptor bent • Replace tip adaptor kit

9.2 Tip adaptor on
page EN-16
• Tip adapter bearing is loose • Replace tip adaptor kit

9.2 Tip adaptor on
page EN-16
• Bearing is worn • Consult your specialist dealer or
the manufacturer
• Motor shaft is bent • Consult your specialist dealer or
the manufacturer
Arc starts and stops
abruptly
• Problems with the wire feeder • See "Problems with the wire
feeder" in this table
• Circuit is closed by additional devices
(e.g. torch guide) or while the power
supply for welding is starting up
• Set the welding start to OFF on
the additional device. Set the
power supply for welding to
OFF. Restart the welding device.
• Failure of the power supply for welding • Inform the manufacturer of the
power supply
Fault Cause Troubleshooting
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Switch off the control device.
• Switch off the entire welding system.
• Close off the gas supply.
• Disconnect all electrical connections.
NOTICE
• Disassembly must only be carried out by qualified personnel
(in Germany, see TRBS 1203).
• Please consult the operating instructions for the welding components, such as the welding power
source and the robot control unit.
• Observe the information provided in the following section:

8 Putting out of operation on page EN-13