Abicor Binzel ABIMIG SpinArc, Руководство по эксплуатации

Страница: 39 / 48

ABIMIG
®
SpinArc
®
9 Maintenance and cleaning
EN - 17
14 Securely connect the tip adaptor (11) to the spin shaft (12) . Insert the tip adapter socket into the inner
bearing so that a gap of approx. 3.2 mm remains between the tip adaptor (11) and the cam (2) .
9.3 Replacing the liner
1 Remove the contact tip (6) and pull out the wire.
2
Separate the cable assembly from the wire feeder.
3 Place the cable on a flat surface.
4
If necessary, take off the cap
(4)
and remove the liner.
5 Cut the new liner to the same length as the old one.
6
Insert the new liner. It should protrude 25 – 32 mm.
7 Put the cap (4) back on.
9.4 Cam
1
Check to ensure that the cam
(2)
can click into place securely at all eight positions.
2 Check that the cam (2) remains in the correct position during rotation and after rotation stops.
3
If necessary, clean the cam
(2)
with compressed air. Make sure that it can rotate freely.
9.5 Control device
1 Check whether the control device settings work for both clockwise and counter-clockwise rotations.
2
Check the power cable for damage and replace if necessary.
3 Check the number of revolutions per minute (Off, 200 to 5,500 s
-1
).
9.6 Flexure

Fig. 8 Maintenance and cleaning on page EN-15
The flexure must be checked and maintained on a regular basis. Its service life depends on the cam settings,
the current intensity and the rotational speed. Exceeding the recommended settings will shorten the service
life.
Fig. 10 Tip adaptor
NOTICE
• Both flexure fasteners (8) , (9) must be securely in position. It is important for these to be securely
attached to enable correct power transmission and a stable arc.