BAL.0085 • 2017-03-02
EN - 11
ABIMIG
®
W
6 Handle control elements
1
Insert the wire into the wire feed unit as specified by the manufacturer.
2
Press the “zero-current wire feed” trigger on the wire feeder until the wire
emerges from the contact tip.
6 Handle control elements
The trigger’s two-cycle mode can be activated when using a standard welding
torch. Further operating modes and handle modules depend on the welding
power source and must be ordered separately
.
6.1 Two-cycle trigger function
1
Press and hold the trigger on the handle = start welding.
2
Release the trigger = stop welding.
7 Operation
1
Open the shielding gas cylinder.
2
Switch on the power source.
3
Set the welding parameters.
4
Start welding.
8 Putting out of operation
1
Stop welding.
2
Wait until the shielding gas post-flow time has passed.
3
Switch off the power source.
4
Close the valve on the shielding gas cylinder.
NOTICE
• The welding torch must only be operated by qualified personnel
(in Germany, see TRBS 1203).
• Please also consult the operating instructions for the welding
components, welding power source and welding torch.
NOTICE
• When putting the system out of operation, ensure that the procedures for
switching off each of the welding system components are observed.
• As liquid-cooled cable assemblies start to leak when they overheat, the
coolant recirculator should continue running for approx. 5 min. after
welding.
