Abicor Binzel AB20, Руководство по эксплуатации

Страница: 7 / 12

EN - 7
AB Series Torches 3 Putting into operation
3.2 Mounting the wire guide liner
1 Lay the torch straight out and unscrew the gas nozzle as well as the contact
tip from the torch neck.
2 Slide the wire guide liner into the torch up to the Panasonic connector; for
the torches with Euro or OTC connector, unscrew the position holder nut on
the connector, insert the wire guide liner in and then screw the position
holder nut back on again.
3 Fold the torch side cable to a degree of 180°, cut off the wire guide liner
at the end of the tip holder.
4 Pull out the wire guide liner.
5 Sharpen the wire guide liner to an angle of approx. 40° and deburr the
cutting edge.
6 Insert the wire guide liner into the torch again; for torches with Euro or OTC
connectors, please screw the position holder nut on the connector and tight
with a spanner.
7 Screw the contact tip and gas nozzle back on again.
3.3 Connecting the torch to machine
1 Insert the Panasonic connector into the wire feed unit, and tight the lock bolt
on the wire feed unit; for Euro or OTC connectors, screw the union nut tight.
2 Properly mount the connections for shielding gas.
3.4 Setting the shielding gas quantity
3.5 Feed in wire
1 Insert the wire in the wire feed unit as specified by the manufacturer.
2 Press the "Wire Jog" push-button at the wire feed unit until the wire comes
out of the contact tip.
NOTE
• The type and quantity of the shielding gas quantity depends on the
welding task and the gas nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly, before connecting
the cylinder. This will blow out any impurities that may be present.