ABB Orion 3 Base, Оригинальное руководство пользователя

Страница: 12 / 42

2TLC172289M0201 Rev C
12 www.abb.com/jokabsafety
2018-04-17
3 Installation
3.1 Precautions to be observed for the choice and installation of the AOPD

The outputs (OSSD) of the AOPD must be used as machine stopping devices and not as command devices.
The machine must have its own Start command.

The dimension of the smallest object to be detected must be larger than the resolution of the AOPD.

The AOPD must be installed in a room complying with the technical characteristics indicated in paragraph
11
– “Technical data”.

Do not place the AOPD near strong and/or flashing light sources or similar devices.

Strong electromagnetic interferences can jeopardize the function of the AOPD. Please contact your
ABB Jokab Safety representative for advice.

The operating distance of the device can be reduced in presence of smog, fog or airborne dust.

A sudden change in environment temperature, with very low minimum peaks, can generate a small
condensation layer on the lenses and so jeopardize the function.
3.2 General information on positioning the AOPD
The AOPD must be carefully positioned, in order to offer effective protection: access to the hazard zone must only be
possible by passing through the detection zone of the AOPD.
Warning! Figure 6 shows some examples of possible access to the machine from the top and the bottom sides.
These situations can be very hazardous and the AOPD must be installed at a correct height in order to completely
cover the access to the hazard zone (see Figure 7).
Figure 6
– Incorrect device positioning
c
Figure 7
– Correct device positioning
NO
YES