Connection and installation
Technical Reference Manual 2CKA001473B9194
│15
5.5
Installation
Note
The devices have been prepared for installing in flush-mounted boxes in
connection with the corresponding mounting plate. The device insert has already
been inserted in the mounting plate.
To install the device, perform the following steps:
Note
The sensor must be pulled
off the flush-mounted insert
before mounting!
1. Turn the device into the correct
installation position.
– The mark "TOP" [1] must be
aligned toward the top.
Note
Observe the correct
polarity!
2. Connect the 230 V power cord to the
bottom terminal block [2], see
chapter “Circuit diagrams“ on page
14
3. Insert the device into the flush-
mounted box and screw it on.
Fig. 7:
Installation
4. Attach the cover frame.
Fig. 8:
Connection of bus
