Evolution Indoor Mini Camera
QUICK START GUIDE
QUICK START GUIDE: Important
•
Read these instructions carefully before installing or
operating this product.
•
This product should be installed by a qualified service
person and the installation should conform to local
and national regulations.
•
This product is only suitable for a surface mount
installation and should not be modified or adapted for
any type of plenum installation.
•
For the latest update on user manual, specifications
and camera firmware, please visit:
www.oncamgrandeye.com/security-systems/
Welcome
The Oncam Grandeye Evolution Indoor 360° Mini
Camera is designed to be connected to an IP network,
and it can be configured and operated using a standard
internet browser software.
This quick start guide describes the installation and
configuration procedures for a standard surface mount
camera application.
If you need more detailed information, please refer to
the:
Oncam Grandeye Evolution Mini Camera - Installation
Guide & User Manual
Available at: http://www.oncamgrandeye.com
1. Note the MAC address
Make a note of the camera’s location and unique MAC
address, which can be found printed on the camera
back label. This information may be needed during
camera configuration.
2 . Mounting options & Installation
2b.
Attach the supplied drilling template
to the installation location. Drill holes
appropriately sized and use wall
plugs.
For concealed-cable entry, use the
supplied drilling template for pilot
hole drilling and drill the clearance
hole in the centre to allow the flying
cable to pass through.
2a.
The Evolution Indoor camera is
intended for mounting on flat
surfaces, such as walls or ceilings.
The integrated RJ45 flying lead
can either be postioned to come
out from the side of the camera (by
carefully removing the cut-out from
the cover side wall) or from the rear
of the mounting base.
2c.
Using the Torx tool (provided in the
box), unscrew the 2x cover Torx
screws.
Carefully remove the front plastic
cover and set it aside.
2e.
Place the front cover back on to the
base. Using the Torx tool, screw
back the 2x cover Torx screws.
*
See warning below
Carefully remove the screen
protection film from the lens.
2d.
Secure the camera base with
the supplied wall plugs and fixing
screws. Ensure the cable is pulled
through from the base correctly.
*
Do not over tighten the Torx screws when putting back the
front cover. Hand operation only. Do not use an electric tool as
this will damage the screws permanently.
Power Input
LPS only to PoE Network Environment 0,
IEEE 802.3af standard
Operating Temp.
0 to +40°C (-32 to +104°F)
Enclosure
ABS Thermoplastic
Weight
250gr (0.55lbs)
90mm / 3.54“
Evolution Indoor Mini Camera
DRILLING TEMPLATE
Scale
Drawing Number
Revision
1:1
DWT-14.11.13-EVM
02/2015
min. 15mm / 0.59“
