ABB MicroFlex e190, Руководство пользователя

Страница: 163 / 210

Technical data 163
Compliance with EN 61800-3, category C4
The drive meets the requirements of the EMC Directive with the following provisions:
1. It is ensured that no excessive emission is propagated to neighbouring low-
voltage networks. In some cases, the natural suppression in transformers and
cables is sufficient. If in doubt, a supply transformer with static screening between
the primary and secondary windings can be used.

Low voltage
Equipment
Low voltage
Equipment
Equipment
(victim)
Supply transformer
Medium voltage network
Static screen
Point of measurement
Drive
Neighbouring network
2. An EMC plan for preventing disturbances is drawn up for the installation. A
template is available from the local ABB representative.
3. The motor and control cables are selected as specified in the chapter Planning
the electrical installation .
4. The drive is installed according to the instructions given in this manual.
Compliance with the European Machinery Directive
This safety related drive complies with the European Union Machinery Directive
requirements for a safety component intended to be integrated into machinery.
Compliance with the machinery directive has been verified according to standards
EN 61800-5-2, IEC 61800-5-2, EN ISO 13849-1, EN 62061, and EN 61508 parts 1 &
2. The drive has been designed, constructed and equipped in such a way that when
installed as instructed in this manual, all hazards of an electrical nature are, or can
be, prevented. The drive complies with EN 61800-5-1 which specifies safety
requirements in terms of electrical, thermal and energy.
Note: The final assembler of the machinery must take the necessary precautions to
prevent all hazards of an electrical nature when integrating this equipment. General
specifications for design of electrical equipment of machinery is given in EN 60204-1
and EN 60204-11. Specifications for electrical equipment are also given in many
standards for specific categories of machinery.