ABB CEMcaptain GAA610-M, Руководство по эксплуатации

Страница: 73 / 100

GAA610-M
ADVANCED EMISSION GAS MONITORING SYSTEM | OI/GAA610-M-EN REV. B 73
Analyzer cabinet – Visual inspection
Figure 35: Frontview of the analyzer system
Visual inspection
Pos. Device, module Nominal condition
1
Main switch ON
2
Gas analyzer display: Measured values, flow
value, status messages, cabinet temperatur Green LED ‘Power’ ON
3
Indicator light ‘Common Alarm’ OFF
4
Indicator light ‘Condensate Level Alarm’ OFF
5
Sample gas cooler temperature 3 °C
6
Level of condensate collection bottle See page 83
7
Air filter of analyzer air conditioner See page 83
8
Sample gas flow 40 to 80 l/h
9
LEDs ‘Condensate alarm’ and ‘Flow alarm’ LEDs OFF
0
Heated line temperature controller 180 °C, ±1 °C
k
Push button ‘Measuring point’ ON
l
Push button ‘Backpurge Status’ OFF
Cleaning hints
• Never use water or any solvents to clean parts inside the
analyzer cabinet.
• Always operate the analyzer system with cabinet door closed.
Remove dust inside the analyzer cabinet using a broom and a
vacuum cleaner.
• Clean the outside of the analyzer cabinet with a wet towel
and mild cleaning agents. Pay attention that no droplets
invade the cabinet.
Status LEDs
The three LEDs next to the screen show the user the gas
analyzer’s status.
Status LED Description
The green ‘Power’ LED lights when the power supply is on.
The yellow ‘Maint’ LED lights when the ‘Maintenance request’
status signal is active.
The ‘STATUS MESSAGE’ softkey appears on the screen at the
same time.
The red ‘Error’ LED lights when the ‘Failure’ status signal or the
overall status signal is active.
The ‘STATUS MESSAGE’ softkey appears on the screen at the
same time.
Note
For detailed information on status messages and status signals
refer to
Possible status messages
on page 59.