Manual for Induction Motors and Generators
8 -
Transport and Unpacking
3BFP 000 050 R0101 REV E
1.
Bearing type for D-end
2.
Bearing type for ND-end
3.
Oil change interval
4.
Viscosity class
5.
Oil quantity for D-end bearing (for self lubricated)
6.
Oil quantity for ND-end bearing (for self lubricated)
7.
Method of lubrication for D-end bearing. Oil flow and pressure for flood lubricated
bearing
8.
Method of lubrication for ND-end bearing. Oil flow and pressure for flood lubricated
bearing
9.
Rotor end float (axial play)
NOTE: The information given on the bearing plate must imperatively be followed. Failure to
do so will void the warranty for the bearings.
2.2 Lifting the machine
Before the machine is lifted, ensure that suitable lifting equipment is available and that the
personnel is familiar with lifting work. The weight of the machine is shown on the rating plate,
dimension drawing and packing list.
NOTE: Use only the lifting lugs or eyes intended for lifting the complete machine. Do not use
any small additional lifting lugs or eyes available, as they are there only for service
purposes.
NOTE: The center of gravity of machines with the same frame may vary due to different
outputs, mounting arrangements and auxiliary equipment.
NOTE: Check that eyebolts or the lifting lugs integrated with the machine frame are
undamaged before lifting. Damaged lifting lugs must not be used.
NOTE: Lifting eyebolts must be tightened before lifting. If needed the position of the eyebolt
must be adjusted with suitable washers.
2.2.1 Lifting a machine in a seaworthy package
The seaworthy package is normally a wooden box, which is covered with lamina paper on the
inside. The seaworthy package should be lifted by forklift from the bottom, or by crane with
lifting slings. The sling positions are painted on the package.
