272 Parameters
Warning/Fault
If the drive is modulating, the external event generates a fault.
Otherwise, the event generates a warning.
3
Defines the source of external event 2. See also parameter
.
For the selections, see parameter
;
b5)
Selects the type of external event 2.
Fault
The external event generates a fault.
0
Warning
The external event generates a warning.
1
Warning/Fault
If the drive is modulating, the external event generates a fault.
Otherwise, the event generates a warning.
3
Defines the source of external event 3. See also parameter
.
For the selections, see parameter
Selects the type of external event 3.
Fault
The external event generates a fault.
0
Warning
The external event generates a warning.
1
Warning/Fault
If the drive is modulating, the external event generates a fault.
Otherwise, the event generates a warning.
3
Defines the source of external event 4. See also parameter
.
For the selections, see parameter
Selects the type of external event 4.
Fault
The external event generates a fault.
0
Warning
The external event generates a warning.
1
Warning/Fault
If the drive is modulating, the external event generates a fault.
Otherwise, the event generates a warning.
3
Defines the source of external event 5. See also parameter
.
For the selections, see parameter
Selects the type of external event 5.
Fault
The external event generates a fault.
0
Warning
The external event generates a warning.
1
Warning/Fault
If the drive is modulating, the external event generates a fault.
Otherwise, the event generates a warning.
3
Selects the source of an external fault reset signal. This signal
will be observed even if it is not the active source in the
current control location (EXT1/EXT2/Local).
(A reset from the active source will be observed regardless of
this parameter.)
0 –> 1 = Reset
Not selected
0.
0
No.
Name/Value
Description
Def
/
FbEq16
Содержание ACS880-x04
