2
motors and 1000 V AC for 480 V AC and 600 V AC motors. 600 V AC for 230 V AC and 480 V AC power lines; 1000 V AC
for 600 V AC power line.
•
Temperature rating:
IEC installations: Select a cable rated for at least 70
°C maximum permissible temperature of
conductor in continuous use. NEC installations: Use 75 °C conductors minimum. Insulation temperature can be
higher as long as the ampacity is based on 75 °C conductors.
•
Select the control cables.
•
Use double-shielded twisted-pair cable for analog signals. Use double-shielded or single-shielded cable for the
digital, relay and I/O signals. Do not run 24 V and 115/230 V signals in the same cable.
•
Protect the drive and input power cable with the correct fuses. See
Ratings, fuses and typical power cables
.
4. Examine the installation site
Examine the drive installation site. Make sure that:
•
The installation site is sufficiently ventilated or cooled to remove heat from the drive.
•
The ambient conditions of the drive meet the specifications. See
•
The wall behind the drive and the material above and below the unit is of non-flammable material.
•
The installation surface is as close to vertical as possible and strong enough to support the drive.
•
There is sufficient free space around the drive for cooling, maintenance and operation. For the minimum free space
Dimensions, weights and free space requirements
•
There are no sources of strong magnetic fields such as high-current single-core conductors or contactor coils near the
drive. A strong magnetic field can cause interference or inaccuracy in the operation of the drive.
5. Install the drive on the wall
Select fasteners that comply with local requirements applicable to wall surface materials, drive weight and application.
R1
R2
R3
R4
R5
R6
R7
R8
R9
mm
in
mm
in
mm
in
mm
in
mm
in
mm
in
mm
in
mm
in
mm
in
a
98
3.85
98
3.85
125
4.92
160
6.30
160
6.30 212.5 8.37 245 9.65 262.5 10.33 345 13.58
b
358 14.09 358 14.09 451 17.75 505 19.88 612 24.10 571 22.50 623 24.53 701 27.61 718 28.29
c
-
-
-
-
-
-
475 18.70 581 22.87 531 20.91 583 22.95 658 25.91 658 25.91
× 4
× 4
× 4
a
b
6 (.23)
11 (.45)
R1…R4 (IP21, UL Type 1)
2
1
4
3
R1..R3:
× 4
R4:
× 6
R4:
× 6
7 (.26)
13 (0.51)
b c
R1...R3:
R4:
2
5
R5…R9 (IP21, UL Type 1)
a
b
200 mm
300 mm
(7.87”)
(11.81”)
1
2
5
7
6b 6a
7 (.26)
13 (0.51)
R5
3
c
4
M6×12
Torx T25
2 N·m
(17 lbf·in)
9 (.35)
7
6
UL Type 12 R4...R9
(IP55, UL Type 12) R1...R9
4
5
6
8
2
3
c
a
b
200 mm
300 mm
(7.87”)
(11.81”)
1