ABB ACS580MV, Руководство по оборудованию

Страница: 43 / 146

Control system and interfaces 43
For detailed information on the parameters for signal allocation, signal type selection,
signal inversion, scaling, and filtering, see:
•
ACS580MV primary control program firmware manual
Control locations and operating modes
The ACS580MV has two main control locations: external and local. The control location is
selected with the
Loc/Rem key on the control panel or in the PC tool.
Refer to ACS580MV primary control program firmware manual .

Application macros
Refer to ACS580MV primary control program firmware manual .
Local operating elements
The local operating elements are located on the front door of the control compartment.

Local control panel
The control panel serves as the basic user interface for operating and monitoring the drive
when the local operating mode has been selected.
The control panel can be attached to or detached from the drive without having to switch
off the auxiliary power supply first.
Using the control panel, it is possible
•
to enter start-up data
•
to control the drive with a reference value, and start, stop and direction commands
•
to display actual values (3 values can be read simultaneously)
•
to display and adjust parameters
•
to display information on the most recent fault events
•
to display history graphs
•
to upload and download complete parameter sets.
The control panel has a status LED that indicates if there are any faults or warnings
present. The table below shows the meaning of the LED indications.
For details on use and maintenance of the control panel refer to ACS-AP-X assistant
control panels user’s manual .
LED status Meaning
Green,
continuous Normal operation
Green,
flickering Data is transferred between the PC tool and drive through the
USB connection of the control panel.
Green,
flashing Alarm pending
Red Drive in fault state.