ABB ACS580-04, Руководство по оборудованию

Страница: 269 / 298

Mechanical installation
￭ Necessary tools
• Screwdriver and a set of suitable bits.
￭
Unpacking and examining the delivery
1. Open the option package. Make sure that the package contains:
•
the option module
• a mounting screw.
2. Make sure that there are no signs of damage.
￭
Installing the module
See section Installing option modules (page 110) .
Electrical installation
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section Electrical safety precautions (page 21)
before you start the work.
￭
Necessary tools
• Screwdriver and a set of suitable bits
￭
Wiring
Connect the external control cables to the applicable module terminals. Ground the
outer shield of the control cables at the cabinet entry.
WARNING!
Do not connect the +24 V AC cable to the control unit ground when the control
unit is powered using an external 24 V AC supply.
Start-up
￭
Setting the parameters
1. Power up the drive.
2. If no warning is shown,
make sure that the value of both parameters 15.01 Extension module type
and 15.02 Detected extension module is CMOD-01. •
If the warning A7AB Extension I/O configuration failure is shown,
•
make sure that the value of parameter 15.02 is CMOD-01.
• set the parameter 15.01 value to CMOD-01.
You can now see the parameters of the extension module in parameter group 15
I/O extension module.
3. Set the parameters of the extension module to applicable values.
CMOD-01 multifunction extension module (external 24 V AC/DC and digital I/O) 269