ABB ACS 600 Series, Руководство по оборудованию

Страница: 73 / 82

ACS/ACC/ACP 604/607 Drives ACx=ACS/ACC/ACP C-3
Appendix C – IEC Installation
IEC Installations This appendix is a supplement to Chapter C – Electrical Installation. It
contains additional information to be used in IEC installations. For
installations requiring CE compliance, refer also to the section entitled
CE Marking in Appendix A.
Power Cables
Symmetrical shielded motor cable must be used (figure below).
Four-conductor system is allowed for mains cabling, but shielded
symmetrical cable is recommended. To operate as a protective
conductor, the shield conductivity must be at least 50 % of the
conductivity of the phase lead.
Compared to a four-conductor system, the use of symmetrical shielded
cable reduces electromagnetic emission of the whole drive system as
well as motor bearing currents and wear.
Compared to a four-conductor system, the use of symmetrical shielded
cable reduces electromagnetic emission of the whole drive system as
well as motor bearing currents and wear.
The motor cable and its PE pigtail should be kept as short as possible
in order to reduce electromagnetic emission as well as capacitive
current.
Alternative Power Cable
Types
Power cable types that can be used with ACx 600 are represented
below.
Symmetrical shielded cable: three phase conductors
and a concentric or otherwise symmetrically
constructed PE conductor, and a shield
Recommended
PE conductor
and shield
Shield
Shield
A separate PE conductor is required if the conductivity
of the cable shield is < 50 % of the conductivity of the
phase conductor.
A four-conductor system:
three phase conductors
and a protective
conductor.
Shield
PE
PE
PE
Not allowed for motor cables larger than
10 mm
2
(motors > 30 kW).
Not allowed for motor cables