ABB ACQ580-34, Руководство по оборудованию

Страница: 26 / 244

The instructions and technical data which concern only certain optional selections are marked
with option codes, eg, +E208. The options included in the drive can be identified from the
option codes visible on the type designation label. The option selections are listed in section
Type designation key (page 38) .
Quick installation, commissioning and operating flowchart
See chapter/section Task
Guidelines for planning the mechanical installa-
tion (page 51)
Plan the mechanical and electrical installation and ac-
quire the accessories needed (cables, fuses, etc.).
Examine the ambient conditions, ratings, required
cooling air flow, input power connection, compatibility
of the motor, motor connection, and other technical
data.
Guidelines for planning the electrical installa-
tion (page 71)
Technical data (page 165)
Option manual (if optional equipment is included)
Moving and unpacking (page 61)
Unpack and examine the units.
Make sure that all necessary optional modules and
equipment are present and correct.
Examining the delivery (page 66)
If the drive module has been non-operational for a year
or more, the converter DC link capacitors need to be
reformed. (
Reforming the capacitors (page 157) )
Only intact units can be started up.
Examining the installation site (page 61)
Examine the installation site. Attach the base of the
cabinet to the floor.
Surrounding air conditions (page 176)
Routing the cables (page 84)
Route the cables.
Measuring the insulation (page 96)
Measure the insulation of the supply cable, the motor
and the motor cable and the resistor cable (if present).
Installing the drive module and LCL filter module into
an enclosure (page 135)
Standard drive modules
•Install the additional components into the enclosure:
for example, main disconnector, main contactor, main
AC fuses, etc..
•Install the drive module into the enclosure.
•Connect the motor cables to the drive module termin-
als.
•Connect the brake resistor and DC connection cables
(if any) to the drive module terminals.
•If the main disconnector is installed into the enclos-
ure, connect it to the drive module terminals and the
input power cabling to the disconnector.
Connecting the motor cables and installing the shrouds
(B051) (page 136)
Connecting the input cables and installing the shrouds
(B051) (page 137)
Connecting the control cables to the integrated control
unit (page 104)
Manuals for any optional equipment
Step-by-step drawings for an installation example of
standard drive configuration in Rittal VX25 800 mm
wide enclosure (page 229)
Drive modules with IP20 shrouds (B051)
Connecting the control cables to the integrated control
unit (page 104)
Connect the control cables to the drive control unit.
Installation checklist (page 141)
Examine the installation.
26 Introduction to the manual