ab command iX2, Инструкция по эксплуатации

Страница: 14 / 16

Q. I noticed a redness of the skin after using the device.
Is this a problem?
A.
A slight redness of the skin after a session with the
AbCommand™ iX2™ fitness belt is normal. It should
fade quickly. Some redness may also be caused by pressure to
the skin from the stretched belt. You should not be concerned
about this. If the redness is excessive, you may not have used
enough Conductive Gel and/or one or more of the Conductive
Pads may have dried out during a longer session. Try using
more Conductive Gel the next time, replenish it after each
10 minute session and use a lower intensity level.
25
TROUBLE SHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
LCD Display does
not light up at all
- Batteries not
installed
- Batteries installed
incorrectly
- Batteries are dead
- Install batteries
- Check polarity “+” sign
- Replace batteries
LCD Display lights
up, but warning
beep is emitted
(high pitched
tone)
- No skin contact
- Unit not snapped
on belt correctly
- Microprocessor
hang up
- Batteries are low
- Use water-based gel on
Conductive Pads and
place belt directly onto
skin.
- Check that unit is
connected firmly with
all connectors to the belt.
- Check that all Conductive
Pads are connected
firmly to the belt.
- Choose intensity mode
and increase intensity by
pushing the up buttons
for left and right
channels
- Remove batteries for
1 minute for full RESET
- Change batteries
LCD Display lights
up, but nothing
occurs
- Intensity set to
low level
- Not enough
Conductive Gel
on belt
- Gel used on the
Conductive Pads is
not water-based
- Choose intensity mode
and increase intensity by
pushing the up buttons
for left and right
channels
- Put more water-based
gel between belt and
skin
- Read label on the gel
that you use. Make
sure you find “water”
or “aqua” in the
ingredient list.
26