© CMS Magnetics 2007, 2008
Confidential
13
Step
5:
Connect
the
cable
to
the
upper
end
of
the
pole
and
lift
gradually.
Step
6:
When
the
tower
is
at
the
upright
position,
align
the
holes
on
the
tower
flange
to
the
holes
on
the
base
flange
and
tighten
them.
Connection of the Charger Controller
IMPORTANT: Refer to Appendix One
To prevent bodily injury or property damage, please follow these instructions precisely.
With personal safety as a primary focus in design, this charge controller has been
engineered to function properly and efficiently.
There are 3 leads coming from the wind generator and they are to be connected to the
charge controller. The connectors to be connected should be marked as wind generator
inputs.
Please make sure that generator is not generating power when you connect the charge
controller and make sure that all the three wires are connected. Not doing so may cause
the system damage or personal injury.
Connection of the Batteries (If Applicable)
Note: All batteries should remain inside dry buildings with a constant temperature.
1. Arrange the batteries, controller and inverter in order of connection prior to actually
connecting the individual components.
2. Connect the batteries in
series
.
3. Lubricate the connectors for better conductance. Install a fuse on the positive
terminal of the battery. The distance between the batteries and the controller should
not exceed 3m.
4. Suggested battery capacity for various models (as shown in table 3)
