![background image](http://html1.mh-extra.com/html/aamstamp/m-2000/m-2000_owners-manual_3211713004.webp)
UNPACKING YOUR NEW AAMSTAMP IMPRINTER
(Please read this entire manual completely before proceeding with this section.)
Reference Page numbers have been included in this section to make finding appropriate information easier.
Read this Owners Guide first.
Unpack and inspect all equipment, accessories and supplies.
Place the 2000 Series Machine on a table capable of supporting 100 or more pounds.
Customer
MUST retain the shippin
g
b
o
x
and custom pac
k
in
g
materials as they are
Required f
or all machine
returns
.
This includes
W
arranty, repair and up
g
rades
.
Aamstamp Machine
w
ill not accept machines shipped in
any container not supplied
w
ith the machine
. I
f you need to return your machine and have not retained its
pac
k
a
g
in
g
, a ne
w
b
o
x
and pac
k
a
g
in
g
Must
b
e purchased,
i
ncludin
g
Shippin
g.
Install Foil Guide Arms. See diagram on page 4. Large washer goes behind rear arm.
Install Machine Handle. You must retract safety slider on Air/Titan machines. See Figure XX.
Turn on po
w
er s
w
itch located on po
w
er cord
Plu
g t
he 2000 Series Machine into a standard 11
5V
ac
/
220
V
ac electrical outlet
,
Dependin
g
on your
machines
factory configuration.
Choose the appropriate ali
g
nment tools for your
job.
See pg. 22.
Load
f
oil
s
ee instructions on pa
g
e
11.
Insert the typeholder into the typehead
.
See pa
g
e .
Set the di
g
ital temperature controller to 220
deg
re
es.
Most products print in the ran
g
e between 220° and 280°.
Allow the machine to warm up for a period of 3-5 minutes. Large type holders may take up to 5 minutes to reach
the proper temperature. See pg XX for instructions on setting the desired temperature.
On the Air/ Titan, the regulator must be turned down to 0 psi for set-ups and manual printing. See page XX for
directions to adjusting the regulator.
Begin printing by pulling down the machine handle. Control quality of print by varying pressure
and dwell
(duration of print). See page XX for examples of the printing triangle.
AIR2000 & TITAN2000: Machine Handle MUST be removed before use. Begin printing by pressing the foot or
two-hand activation switch(s). Safety shield must be in the lowered position. Be sure your hands are clear and that
the product is appropriately lined up under the typehead. Be sure that the typehead and type/die holders have
adequate clearance and will not collide with any of the setup alignment tools such as the 10x12 base plate. Control
the quality of print by varying the pressure and dwell (duration of print).
3
Select the appropriate cushion board, if necessary. See pg. 18. Do Not allow type to contact table plate as damage
to type will occure.