4
Installation Guide
phone - 1-800-477-2267
email - [email protected]
Fitting Instructions - (continued)
Sensor Install: Sensors must be installed in order 1-4 from left to right with control
module harness entering trunk near sensor #4.
Choosing the Correct Angle Sleeve
(Optional angle gauge: SP1022)
Vehicle is parked on flat and level ground and
the parking brake is set. Place the Angle Gauge
flat against the surface of the bumper. The
swingarm will point to the correct measurement.
DO NOT CONTINUE TO NEXT STEP IF ARM
FALLS BEYOND THE LAST LINE ON THE MARKER!
This means that the placement is too steep; reevaluate
placement and find a better area.
Drilling Holes and Installing Sensors
Warnings / Precautions:
Please consult with us before installing on a vehicle with any
rear or front mounted external appliances, like spare tires, bike racks, brush guards,
etc, which may interfere with the system’s detection and cause false detection.
Using the provided Hole Saw, cut the
sensor holes. Always wear approved
safety glasses when drilling and use
caution. If drilling a metal bumper, coat
edges of holes with Zinc Galvanizer, a
rust inhibitor. Metal bumpers also require
the use of rubber sleeves with installation
of sensors.
Ensure correct angle sleeve
is being used. Insert sensor
with the “up” marking
facing up.
(2) Mount Sensor
(1) The Sensor Holes
PS-TRUCK30
ParkAlert Digital Rear Sensing System
with Extended Harness for Trucks
Rubber sleeves must be oriented with
‘UP’ notation mounted up.
