6
Installation Guide
phone - 1-800-477-2267
email - [email protected]
Fitting Instructions - (continued)
You will want to mount the control module behind one of the vehicle’s body panels.
Clean a suitable location using the provided alcohol swab. Plug in all the wires, adjust
dip switches, then peel backing of Velcro liner to mount. Finish by securing any loose
and/or excess wiring. Before reassembling any panels that might have been removed
from the vehicle, test the system.
Mounting Control Module
Choosing Correct Dip Switch Configuration
Switch
Vertical Angle
1
Down: Original Coverage Range
Up: Reduce 20% Coverage Range
Switch
Zone Range
2 & 3
Down & Down: Default Zone Range
Down & Up: Add 20in to Range
Up & Down: Add 28in to Range
Switch
Sensor Spacing (in)
4 & 5
Down & Down: 16-16-16
Down & Up: 14-20-14
Up & Down: 12-24-12
Up & Up: 8-32-8
For most vehicles, all switches DOWN will work fine.
However, should you need to make changes,
please see below.
PS-TRUCK30
ParkAlert Digital Rear Sensing System
with Extended Harness for Trucks
