![background image](http://html1.mh-extra.com/html/aaeon/pcm-5894/pcm-5894_user-manual_3326663030.webp)
22
PCM-5894 User's Manual
IDE hard drive connector (CN11)
You can attach one or two Enhanced Integrated Device Electron-
ics hard disk drives to the mainboard's internal controller. The
mainboard's IDE controller uses a PCI local-bus interface. This
advanced interface supports fster data transfer and allows the IDE
hard drive to exceed 528 MB.
Connecting the hard drive
Connecting drives is done in a daisy-chain fashion and requires
one of two cables, depending on the drive size. 1.8" and 2.5"
drives need a 1 x 44-pin to 2 x 44-pin flat-cable connector. 3.5"
drives use a 1 x 44-pin to 2 x 40-pin connect.
Wire number 1 on the cable is red or blue, and the other wires are
gray.
1. Connect one end of the cable to CN11. Make sure that the red
(or blue) wire corresponds to pin 1 on the connector, which is
labeled on the board (on the right side).
2. Plug the other end of the cable to the Enhanced IDE hard
drive, with pin 1 one the cable corresponding to pin 1 on the
hard drive. (See your hard drive's documentation for the
location of the connector).
Connect a second drive as described above.
Unlike drives, IDE hard drives can connect to either end of the
cable. If you install two drives, you will need to set one as the
master and one as the slave by using jumpers on the drives. If
you install just on drive, set it as the master.
Содержание PCM-5894
