Spa & Pool Treatment
The Aqua-6 can be used on spas, hot tubs and wading pools up to
500 gallons
. This allows
chemical usage to be reduced significantly. Limit dry skin, red eyes, faded suits or green
hair that is the result of chlorine exposure. Ozone is pH neutral, so it will not adversely
impact the acid or alkaline balance of the water. It is more cost effective than traditional
chemicals and leaves no undesirable smell behind.
Continuous operation (10 to 20 minutes;
Function 9
or
Function 10
) is proven to be the
most economical treatment method for spa water, fountains and larger bodies of water up
to 500 gallons.
For greater volumes, see our larger output ozonators at
www.a2zozone.com.
1.
The Aqua-6 must be sheltered from direct exposure from the elements (rain and water).
a.
Place the unit at least five feet from the spa or water enclosure and at least twelve
inches above the maximum water level.
b.
Ensure that the location is out of the reach of children or anyone in the water.
2.
Connect the ozone supply tube to the ozone outlet vent at the bottom of the unit.
a.
If the ozone supply tubing is too long, trim it with household scissors or a razor
knife.
3.
Place the white diffuser stone 4 inches into the body of water near the center for
maximum ozone saturation in the water.
4.
Plug the Aqua-6 into a ground fault circuit interrupter (GFCI) protected outlet.
5.
Turn the unit on and set it to the desired program function and wait until it starts in 10
seconds.
10
Содержание Aqua-6
Страница 6: ...1 8 4 5 6 2 7 3 5 ...