5.Installation
4. Dimensions
Then isolate them with a suitable insulating
tape (not included).
3. Connect the solar panel with the positive
4. Check the status of the
LED display (see section 10).
corresponding cables
(positive pole=red (1) // negative pole=black (2)).
1. First connect the load with the
Make sure the cable lengths between the
battery and the controller are as short as
possible. Make sure that the cable cross-
section is sufficient and that you connect
it in the correct order:
The controller starts
charging.
MPPT solar charge controller X45/10
operation manual
page 7
02/2022
Machine Translated by Google
2. Then connect the battery.
It applies again
(positive pole=red (3) // negative pole=black (4)).
cable (5) and the negative cable (6).
The load should now be switched on.
