5 PERIODIC MAINTENANCE
Pag. 21 di 26
5.3
Maintenance every 1000 hours
1.
Check the condition of upper and lower sliding devices if an excessively worn component is
found, it is recommended to replace the entire assembly of the component in question.
2.
Also carry out the operations listed in the previous point (
Points 06.01
and
06.02
5.4
Maintenance every 2000 hours
1.
Proceed with a thorough inspection of the equipment; this, possibly, must be performed by
qualified personnel, able to identify any problems that could compromise the safety and
efficiency of use of the equipment. The defects that can be found can be many:
- Check the condition of all equipment components (cylinders, hooks, gaskets, fittings,
grease nipples, etc.), verifying that their conditions are optimal and, if there are worn
components, proceed with their replacement / repair.
- Check the condition of the sliding and working surfaces and proceed with their
replacement / repair if they are damaged.
For further possible problems (and relative solutions) refer also to
2.
Disassemble the cylinders and check the condition of the rods and seals, if there is a
damaged or excessively worn seal, it is always recommended to replace the entire assembly
seals.
3.
Replace the seals even in the event of oil leaks and the rods if scratched (the cylinders must
always be tested inserted in the equipment in order to avoid the sudden expulsion of the
rods).
4.
Also carry out the operations listed in the previous points (
Point 06.01
, and
points
06.02
06.03
Please Note: Intensify interventions in case of use in particularly severe conditions
