A SYSTEMS DMP801, Руководство пользователя

Страница: 5 / 42

3
DMP801
English
8.
AC Power Connector
This is for a standard IEC power cable�
9. 24V DC Connector
This connector is used for backup power� E�g� UPS or
battery�
10. RJ-45 Connector
Used for connecting DMP801 to local network for
remote control�
11. UNIT ID switch set
1 rotary switch and 1 8-PIN dip switch. (see section
UNIT ID Switch Set)
12. INPUT Connector
DMP 801 offers two types of input connector: Euroblock
and balanced 14”TRS�
13. MIX Output
DMP801 offers a single 3-pin Euroblock output
connector� This connector can be set as balanced or
unbalanced. (see Installation and Setup section)
REAR PANEL
UNIT ID Switch Set
The UNIT ID switch set consist of a rotary switch and an 8-PIN DIP switch� These essentially adjust various controls and
settings as well as things like firmware updates, IP address settings (by hardware) and factory default.Firmware Upgrade
8
7
65
4 3
2 1 0 F E
D C
BA
9
upper position: ON
Iower position: OFF
PIN
1
Function Position Description Note
Firmware upgrade
Firmware Upgrade Mode ON
Operation Mode OFF
2 IP address setting method selection
By hardware ON
By Software OFF
3
The leading digit of
the host bits of IP address
Please see the section
“How to set Unit ID”
Disabled when
PIN 2 is OFF
ON
OFF
4
The last digit of
the host bits of IP address
ON
OFF
6
Enable/Disable Panel VR
Panel VR enabled ON
Panel VR disabled OFF
7
Resume to the factory default
Resume to the factory default ON
Operation Mode OFF
8-PIN DIP Switch Functions