HEATING
TIMER
TEST
12
The value of the set temperature can be increased or decreased by one unit when the
button is pressed. If the button is pressed continuously, the setting temperature increases
or decreases continuously. If the button is released, it will exit the temperature setting
mode after the flashing stops. The temperature setting is within 35°C - 75°C.
3
Timer
Press the “TIMER” button to set the time this is when the water heater will start to heat.
The setting range is from 23 to 0. The running mode of TIMER is countdown mode, for
example, if the user wants the water heater to start heating 7 hours later, set the digital
LED to 7, the timer will start to count, 7 hours later, the heater will start to heat.
After pressing the “TIMER” button, the digital LED will flash, then press the “
“ or “
“
button to set the time when you want to heat the heater, when user stops pressing the
“
” or “
“ button, the digital LED will stop flashing. 4 seconds later, the timer setting
completes then the LED displays the actual temperature.
In the “TIMER” mode, the green light besides the “TIMER” button will be lit. The setting
time will be memorized until the “TIMER” button is pressed and the TIMER mode is
cancelled.
Note:
In case there is an interruption in power supply in your premises, the green light
beside the timer button ceases to glow. The user would need to set the countdown timer
again as mentioned above.
4
TEST button
Press the TEST button to test whether the current leakage protection function is normal in
the controller.
